Captured node attacking incorrect node [RESOLVED]
Posted: Mon Nov 26, 2018 8:36 pm
I have encountered this issue before and had been only an annoyance. But recently it occurred in a configuration that was of a more severe impact. While attacking a network there was a node that connected to a code gate and another security node, I used a wraith on the security node and left the code gate alone as both nodes
Code: Select all
connected to the same node on the back side. The intent was to disable the security node, attack it and go around the code gate. But the worm program attacked the code gate instead of the disabled security node. There doesn't appear to be an way to direct an attacking node to a target of my choosing. Once the code gate was circumvented I intended the remaining worm programs to attack the code gate as it was no longer of consequence. As I disabled the code gate behind the one being attacked in the attached screen shot. Please see attached screen shot. Scratch that, the screen shot .jpg file is too big at 397k.